blob: 9d6c9feb12ff191b707821b3314be092fbb7b393 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
|
* Socionext NetSec Ethernet Controller IP
Required properties:
- compatible: Should be "socionext,synquacer-netsec"
- reg: Address and length of the control register area, followed by the
address and length of the EEPROM holding the MAC address and
microengine firmware
- interrupts: Should contain ethernet controller interrupt
- clocks: phandle to the PHY reference clock
- clock-names: Should be "phy_ref_clk"
- phy-mode: See ethernet.txt file in the same directory
- phy-handle: See ethernet.txt in the same directory.
- mdio device tree subnode: When the Netsec has a phy connected to its local
mdio, there must be device tree subnode with the following
required properties:
- #address-cells: Must be <1>.
- #size-cells: Must be <0>.
For each phy on the mdio bus, there must be a node with the following
fields:
- compatible: Refer to phy.txt
- reg: phy id used to communicate to phy.
Optional properties: (See ethernet.txt file in the same directory)
- dma-coherent: Boolean property, must only be present if memory
accesses performed by the device are cache coherent.
- max-speed: See ethernet.txt in the same directory.
- max-frame-size: See ethernet.txt in the same directory.
The MAC address will be determined using the optional properties
defined in ethernet.txt.
Example:
eth0: ethernet@522d0000 {
compatible = "socionext,synquacer-netsec";
reg = <0 0x522d0000 0x0 0x10000>, <0 0x10000000 0x0 0x10000>;
interrupts = <GIC_SPI 176 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clk_netsec>;
clock-names = "phy_ref_clk";
phy-mode = "rgmii";
max-speed = <1000>;
max-frame-size = <9000>;
phy-handle = <&phy1>;
mdio {
#address-cells = <1>;
#size-cells = <0>;
phy1: ethernet-phy@1 {
compatible = "ethernet-phy-ieee802.3-c22";
reg = <1>;
};
};
|
