Age | Commit message (Expand) | Author |
2015-01-16 | ath9k: fix BE/BK queue order | Felix Fietkau |
2015-01-16 | ath9k_hw: fix hardware queue allocation | Felix Fietkau |
2014-06-07 | ath9k: protect tid->sched check | Stanislaw Gruszka |
2014-03-23 | ath9k: Fix ETSI compliance for AR9462 2.0 | Sujith Manoharan |
2014-02-22 | ath9k_htc: make ->sta_rc_update atomic for most calls | Stanislaw Gruszka |
2014-01-09 | ath9k_htc: properly set MAC address and BSSID mask | Mathy Vanhoef |
2014-01-09 | ath9k: Fix interrupt handling for the AR9002 family | Sujith Manoharan |
2013-12-20 | ath9k: Fix XLNA bias strength | Sujith Manoharan |
2013-12-20 | ath9k: Fix QuickDrop usage | Sujith Manoharan |
2013-11-13 | ath9k: fix tx queue scheduling after channel changes | Felix Fietkau |
2013-09-26 | ath9k: avoid accessing MRC registers on single-chain devices | Felix Fietkau |
2013-09-26 | ath9k: fix rx descriptor related race condition | Felix Fietkau |
2013-09-26 | ath9k: always clear ps filter bit on new assoc | Felix Fietkau |
2013-09-07 | mac80211: add a flag to indicate CCK support for HT clients | Felix Fietkau |
2013-09-07 | ath9k: Enable PLL fix only for AR9340/AR9330 | Sujith Manoharan |
2013-09-07 | ath9k_htc: Restore skb headroom when returning skb to mac80211 | Helmut Schaa |
2013-08-11 | ath9k_htc: reboot firmware if it was loaded | Oleksij Rempel |
2013-08-11 | ath9k_htc: do some initial hardware configuration | Oleksij Rempel |
2013-07-25 | ath9k: Do not assign noise for NULL caldata | Sujith Manoharan |
2013-07-25 | ath9k: Fix noisefloor calibration | Sujith Manoharan |
2013-07-25 | ath9k_hw: Assign default xlna config for AR9485 | Sujith Manoharan |
2013-06-24 | ath9k_htc: Handle IDLE state transition properly | Sujith Manoharan |
2013-06-24 | ath9k: fix an RCU issue in calling ieee80211_get_tx_rates | Felix Fietkau |
2013-06-12 | ath9k: Use minstrel rate control by default | Sujith Manoharan |
2013-06-12 | Revert "ath9k_hw: Update rx gain initval to improve rx sensitivity" | Felix Fietkau |
2013-06-12 | ath9k: Disable PowerSave by default | Sujith Manoharan |
2013-05-28 | ath9k: use correct OTP register offsets for AR9550 | Gabor Juhos |
2013-05-24 | ath9k_hw: improve performance for AR934x v1.3+ | Felix Fietkau |
2013-05-24 | ath9k_hw: fix host interface reset on AR934x | Felix Fietkau |
2013-05-24 | ath9k_hw: fix spur mitigation issues on AR934x | Felix Fietkau |
2013-05-22 | ath9k: prevent aggregation session deadlocks | Felix Fietkau |
2013-05-17 | ath9k: fix draining aggregation tid buffers | Felix Fietkau |
2013-05-17 | ath9k: fix rate handling/reporting | Felix Fietkau |
2013-05-17 | ath9k: fix aggregation stop/flush handling | Felix Fietkau |
2013-05-17 | ath9k_hw: Enable manual peak calibration for AR9485 | Sujith Manoharan |
2013-05-17 | ath9k: Fix crash on module unload | Sujith Manoharan |
2013-05-17 | net/wireless: ATH9K should depend on HAS_DMA | Geert Uytterhoeven |
2013-05-08 | ath9k: Update initvals for AR9565 | Sujith Manoharan |
2013-05-08 | ath9k: Fix beacon reconfiguration | Sujith Manoharan |
2013-05-03 | ath9k: fix key allocation error handling for powersave keys | Felix Fietkau |
2013-04-23 | ath9k: Fix RX DMA mapping | Sujith Manoharan |
2013-04-23 | ath9k: Use lockless variants for the RX fifo queue | Sujith Manoharan |
2013-04-23 | ath9k: Reduce deep indentation | Sujith Manoharan |
2013-04-23 | ath9k: Remove unused argument "size" | Sujith Manoharan |
2013-04-23 | ath9k: add support for the new rate control API | Felix Fietkau |
2013-04-23 | ath9k: merge ath_tx_start_dma into ath_tx_start | Felix Fietkau |
2013-04-23 | ath9k: apply coverage class on slottime too | Mathias Kretschmer |
2013-04-23 | Merge branch 'master' of git://git.kernel.org/pub/scm/linux/kernel/git/linvil... | John W. Linville |
2013-04-22 | ath9k: always set common->macaddr to the MAC adress of a virtual interface | Felix Fietkau |
2013-04-22 | ath: update hardware mac address with bssid mask | Felix Fietkau |