diff options
Diffstat (limited to 'include/linux/spi/spi.h')
| -rw-r--r-- | include/linux/spi/spi.h | 41 |
1 files changed, 40 insertions, 1 deletions
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h index cb2c2df31089..af7cfee7b8f6 100644 --- a/include/linux/spi/spi.h +++ b/include/linux/spi/spi.h @@ -23,6 +23,9 @@ /* Max no. of CS supported per spi device */ #define SPI_DEVICE_CS_CNT_MAX 4 +/* Max no. of data lanes supported per spi device */ +#define SPI_DEVICE_DATA_LANE_CNT_MAX 8 + struct dma_chan; struct software_node; struct ptp_system_timestamp; @@ -174,6 +177,10 @@ extern void spi_transfer_cs_change_delay_exec(struct spi_message *msg, * @cs_index_mask: Bit mask of the active chipselect(s) in the chipselect array * @cs_gpiod: Array of GPIO descriptors of the corresponding chipselect lines * (optional, NULL when not using a GPIO line) + * @tx_lane_map: Map of peripheral lanes (index) to controller lanes (value). + * @num_tx_lanes: Number of transmit lanes wired up. + * @rx_lane_map: Map of peripheral lanes (index) to controller lanes (value). + * @num_rx_lanes: Number of receive lanes wired up. * * A @spi_device is used to interchange data between an SPI target device * (usually a discrete chip) and CPU memory. @@ -242,6 +249,12 @@ struct spi_device { struct gpio_desc *cs_gpiod[SPI_DEVICE_CS_CNT_MAX]; /* Chip select gpio desc */ + /* Multi-lane SPI controller support. */ + u8 tx_lane_map[SPI_DEVICE_DATA_LANE_CNT_MAX]; + u8 num_tx_lanes; + u8 rx_lane_map[SPI_DEVICE_DATA_LANE_CNT_MAX]; + u8 num_rx_lanes; + /* * Likely need more hooks for more protocol options affecting how * the controller talks to each chip, like: @@ -401,6 +414,7 @@ extern struct spi_device *spi_new_ancillary_device(struct spi_device *spi, u8 ch * SPI targets, and are numbered from zero to num_chipselects. * each target has a chipselect signal, but it's common that not * every chipselect is connected to a target. + * @num_data_lanes: Number of data lanes supported by this controller. Default is 1. * @dma_alignment: SPI controller constraint on DMA buffers alignment. * @mode_bits: flags understood by this controller driver * @buswidth_override_bits: flags to override for this controller driver @@ -576,6 +590,14 @@ struct spi_controller { */ u16 num_chipselect; + /* + * Some specialized SPI controllers can have more than one physical + * data lane interface per controller (each having it's own serializer). + * This specifies the number of data lanes in that case. Other + * controllers do not need to set this (defaults to 1). + */ + u16 num_data_lanes; + /* Some SPI controllers pose alignment requirements on DMAable * buffers; let protocol drivers know about these requirements. */ @@ -882,6 +904,15 @@ extern int devm_spi_register_controller(struct device *dev, struct spi_controller *ctlr); extern void spi_unregister_controller(struct spi_controller *ctlr); +#if IS_ENABLED(CONFIG_OF) +extern struct spi_controller *of_find_spi_controller_by_node(struct device_node *node); +#else +static inline struct spi_controller *of_find_spi_controller_by_node(struct device_node *node) +{ + return NULL; +} +#endif + #if IS_ENABLED(CONFIG_ACPI) && IS_ENABLED(CONFIG_SPI_MASTER) extern struct spi_controller *acpi_spi_find_controller_by_adev(struct acpi_device *adev); extern struct spi_device *acpi_spi_device_alloc(struct spi_controller *ctlr, @@ -959,6 +990,8 @@ struct spi_res { * (SPI_NBITS_SINGLE) is used. * @rx_nbits: number of bits used for reading. If 0 the default * (SPI_NBITS_SINGLE) is used. + * @multi_lane_mode: How to serialize data on multiple lanes. One of the + * SPI_MULTI_LANE_MODE_* values. * @len: size of rx and tx buffers (in bytes) * @speed_hz: Select a speed other than the device default for this * transfer. If 0 the default (from @spi_device) is used. @@ -1095,6 +1128,12 @@ struct spi_transfer { unsigned cs_change:1; unsigned tx_nbits:4; unsigned rx_nbits:4; + +#define SPI_MULTI_LANE_MODE_SINGLE 0 /* only use single lane */ +#define SPI_MULTI_LANE_MODE_STRIPE 1 /* one data word per lane */ +#define SPI_MULTI_LANE_MODE_MIRROR 2 /* same word sent on all lanes */ + unsigned multi_lane_mode: 2; + unsigned timestamped:1; bool dtr_mode; #define SPI_NBITS_SINGLE 0x01 /* 1-bit transfer */ @@ -1270,7 +1309,7 @@ static inline struct spi_message *spi_message_alloc(unsigned ntrans, gfp_t flags } *mwt; unsigned i; - mwt = kzalloc(struct_size(mwt, t, ntrans), flags); + mwt = kzalloc_flex(*mwt, t, ntrans, flags); if (!mwt) return NULL; |