From 37bed97f00734ce329495823d9682181028b51e4 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Mon, 14 May 2018 10:06:23 +0200 Subject: regulator: gpio: Get enable GPIO using GPIO descriptor We augment the GPIO regulator to get the *enable* regulator GPIO line (not the other lines) using a descriptor rather than a global number. We then pass this into the regulator core which has been prepared to hande enable descriptors in a separate patch. Switch over the two boardfiles using this facility and clean up so we only pass descriptors around. Cc: Philipp Zabel # HX4700/Magician maintainer Signed-off-by: Linus Walleij Signed-off-by: Mark Brown --- include/linux/regulator/gpio-regulator.h | 3 --- 1 file changed, 3 deletions(-) (limited to 'include/linux/regulator') diff --git a/include/linux/regulator/gpio-regulator.h b/include/linux/regulator/gpio-regulator.h index 19fbd267406d..536cab86f2d5 100644 --- a/include/linux/regulator/gpio-regulator.h +++ b/include/linux/regulator/gpio-regulator.h @@ -44,8 +44,6 @@ struct gpio_regulator_state { /** * struct gpio_regulator_config - config structure * @supply_name: Name of the regulator supply - * @enable_gpio: GPIO to use for enable control - * set to -EINVAL if not used * @enable_high: Polarity of enable GPIO * 1 = Active high, 0 = Active low * @enabled_at_boot: Whether regulator has been enabled at @@ -69,7 +67,6 @@ struct gpio_regulator_state { struct gpio_regulator_config { const char *supply_name; - int enable_gpio; unsigned enable_high:1; unsigned enabled_at_boot:1; unsigned startup_delay; -- cgit v1.2.3