From b57d6b996ebe25e7f1e92de0abc7a2da42005454 Mon Sep 17 00:00:00 2001 From: Marcel Ziswiler Date: Fri, 31 Aug 2018 18:38:16 +0200 Subject: ARM: tegra: apalis_t30: support v1.1 hardware revision Support the V1.1 hardware revisions with the following change: Changed power rail for MMC1 interface to a 3.3V/1.8V switchable rail in order to be able to run UHS SD cards in ultra high speed 1.8V mode. [ 207.502011] mmc2: host does not support reading read-only switch, assuming write-enable [ 207.517011] mmc2: new ultra high speed SDR104 SDHC card at address aaaa [ 207.534190] mmcblk2: mmc2:aaaa SE32G 29.7 GiB [ 207.545096] mmcblk2: p1 root@apalis-t30:~# cat /sys/kernel/debug/mmc2/ios clock: 208000000 Hz actual clock: 204000000 Hz vdd: 21 (3.3 ~ 3.4 V) bus mode: 2 (push-pull) chip select: 0 (don't care) power mode: 2 (on) bus width: 2 (4 bits) timing spec: 6 (sd uhs SDR104) signal voltage: 1 (1.80 V) driver type: 0 (driver type B) root@apalis-t30:~# hdparm -t /dev/mmcblk2 /dev/mmcblk2: Timing buffered disk reads: 256 MB in 3.02 seconds = 84.71 MB/sec Signed-off-by: Marcel Ziswiler Reviewed-by: Rob Herring Signed-off-by: Thierry Reding --- arch/arm/boot/dts/Makefile | 1 + 1 file changed, 1 insertion(+) (limited to 'arch/arm/boot/dts/Makefile') diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile index b5bd3de87c33..9d6d7790d627 100644 --- a/arch/arm/boot/dts/Makefile +++ b/arch/arm/boot/dts/Makefile @@ -1071,6 +1071,7 @@ dtb-$(CONFIG_ARCH_TEGRA_2x_SOC) += \ tegra20-ventana.dtb dtb-$(CONFIG_ARCH_TEGRA_3x_SOC) += \ tegra30-apalis-eval.dtb \ + tegra30-apalis-v1.1-eval.dtb \ tegra30-beaver.dtb \ tegra30-cardhu-a02.dtb \ tegra30-cardhu-a04.dtb \ -- cgit v1.2.3