diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/mtd/devices/st_spi_fsm.c | 40 |
1 files changed, 40 insertions, 0 deletions
diff --git a/drivers/mtd/devices/st_spi_fsm.c b/drivers/mtd/devices/st_spi_fsm.c index 3e13d579aef8..7cc4425e7f1f 100644 --- a/drivers/mtd/devices/st_spi_fsm.c +++ b/drivers/mtd/devices/st_spi_fsm.c @@ -210,6 +210,8 @@ struct stfsm { uint32_t fifo_dir_delay; bool booted_from_spi; + bool reset_signal; + bool reset_por; }; struct stfsm_seq { @@ -521,6 +523,40 @@ static void stfsm_read_fifo(struct stfsm *fsm, uint32_t *buf, } } +/* + * SoC reset on 'boot-from-spi' systems + * + * Certain modes of operation cause the Flash device to enter a particular state + * for a period of time (e.g. 'Erase Sector', 'Quad Enable', and 'Enter 32-bit + * Addr' commands). On boot-from-spi systems, it is important to consider what + * happens if a warm reset occurs during this period. The SPIBoot controller + * assumes that Flash device is in its default reset state, 24-bit address mode, + * and ready to accept commands. This can be achieved using some form of + * on-board logic/controller to force a device POR in response to a SoC-level + * reset or by making use of the device reset signal if available (limited + * number of devices only). + * + * Failure to take such precautions can cause problems following a warm reset. + * For some operations (e.g. ERASE), there is little that can be done. For + * other modes of operation (e.g. 32-bit addressing), options are often + * available that can help minimise the window in which a reset could cause a + * problem. + * + */ +static bool stfsm_can_handle_soc_reset(struct stfsm *fsm) +{ + /* Reset signal is available on the board and supported by the device */ + if (fsm->reset_signal && fsm->info->flags & FLASH_FLAG_RESET) + return true; + + /* Board-level logic forces a power-on-reset */ + if (fsm->reset_por) + return true; + + /* Reset is not properly handled and may result in failure to reboot */ + return false; +} + /* Configure 'addr_cfg' according to addressing mode */ static void stfsm_prepare_erasesec_seq(struct stfsm *fsm, struct stfsm_seq *seq) @@ -786,6 +822,10 @@ static void stfsm_fetch_platform_configs(struct platform_device *pdev) if (IS_ERR(regmap)) goto boot_device_fail; + fsm->reset_signal = of_property_read_bool(np, "st,reset-signal"); + + fsm->reset_por = of_property_read_bool(np, "st,reset-por"); + /* Where in the syscon the boot device information lives */ ret = of_property_read_u32(np, "st,boot-device-reg", &boot_device_reg); if (ret) |